All boards are made with the size 160x100 mm, Euro-bus connection
with 64 pin connector
|
Type
|
Features
|
|
DSP-Board
C32 F
datasheet *.pdf
|
- DSP TMS320C32, 60 MHz, 60 Mflops, Float Point commands, 2 Timers,
2 DMA, programmable Wait States, Boot from FLASH, Boot from Link.
- 512K x 16 Bit Flash, 256K x 32 Bit zero wait states SRAM, 64K x 16
Bit Ports
- Serial interface RS232, standard D-Sub-9M connector on front panel
- Serial synchronous interface RS422 TI 10 Mbod for connecting multiple
boards C32F
- 8 TTL Inputs, 6 TTL Outputs
- Watchdog
- LEDs for Status, Error, power supply 5V, 12V on front panel
- Multiple boards on one Bus possible
- Timer signal on Bus
- FLASH-Software for linear and circle interpolation, 3 Axes, DIN/ISO
or HPGL
|
|
Servo
board DEP48
datasheet *.pdf
|
- 4 incremental encoder inputs
A,B,I rs422
- 8 channels DAC 12 bit 10
V bipolar
- 4 optically isolated inputs
24 v
- Complete solution for 4
axis Servo drive
|
|
Servo
Board UC48
datasheet
*.pdf
|
- Control step and brushless
PM motors
- 4 channels for analog inputs
sin-cos-ref 11 mkA for 4 encoders
- Software interpolations
for encoder resolutions up to 4096 times
- Nanometer resolutions with
standard 20 mkm encoders
- 8 inputs analog 12 Bit
10 V bipolar for demand currents or velocities of axes
- 4 opto-coupled inputs 24
V for reference switches
- Complete control up to
4 servo-axis (Portal X1,X2,Y,
|
|
Input/Output
Board SPSIO
datasheet *.pdf
|
- 16 Inputs 24 v, 10 mA, optocoupled,
negative polarity protected
- 16 Outputs 24 v, 1 A, overcurrent
protected, inductive load protected
- Base address setting by
jumper
|
Step
/ Dir
Interface Board
IDP4 
datasheet *.pdf
|
- Step / Direction Interface
for 4 axis
- Euro-board 160 x 100 mm,
Eurobus connection with 64 pin connector
- D-Sub-37 connector for
four Step, Dir, Reset and Ready signals.
- Complete control up to
4 stepper or servo-axis (Portal X1,X2,Y,Z)
- 4 channels RS422 Interface
- Base address settings per
jumper, multiple boards at the same bus possible
|
|
Power Amplifier
board PU6
|
- 2 current-feedback full
bridge amplifiers
- Power supply voltage
70 V, output current 6A
- peak current 9A.
- Two bipolar analog inputs
10V for demand current
- Complete solution for two-phase
micro-step and servo motors
|
